TM 9-2320-365-20-1
2-953
CONTINUITY TEST
(1) Remove kick panel (para 16-3).
(2) Disconnect connector P210 from connector
J210.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
connector P903-1.
(5) Connect negative (-) probe of multimeter to
connector P210-14 and note reading on
multimeter.
(6) If continuity is not present, repair wire 2005
(para 2-40) or replace auxiliary panel cable
assembly (all models except M1079 w/o winch
(para 7-49).
(7) Connect connector P903 to WINCH IN/OUT
switch.
(8) Position auxiliary panel on auxiliary panel
housing with six screws.
(9) Tighten six screws to 24 lb-in. (3 N·m).
