CONTINUITY TEST Change 1         2-1017 TM 9-2320-365-20-1 Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact. NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. CAUTION   (1)  Lower cab (TM 9-2320-365-10).   (2)  Remove instrument panel for access         (para 7-15).   (3)  Disconnect connector J31 from connector         P31.   (4)  Set multimeter to ohms.   (5)  Connect positive (+) probe of multimeter         to relay K11 terminal 87A on PDP.   (6)  Connect negative (-) probe of multimeter to         connector J31 pin 1 and note reading on         multimeter.   (7)  If continuity is not present, repair wire         568A from connector J31 pin 1 to relay         K11 terminal 87A (para 2-40) on PDP or         replace WTEC II dashboard cable assembly         (para 7-10) or WTEC III dashboard cable         assembly (para 7-11).   (8)  If continuity is present, repair wire 568A         from connector P31 socket 1 to terminal         lug TL35 (para 2-40) or replace engine         control cable assembly (para 7-72).   (9)  Connect connector J31 to connector P31. (10)  Install instrument panel (para 7-15). (11)  Install relay K11 in PDP. (12)  Install PDP cover (para 16-2). (13)  Connect batteries (para 7-48).