TM 9-2320-365-20-1
2-1025
CONTINUITY TEST
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector J7-1.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire 1426
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10).
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector J7-2.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire 1408
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10).
