TM 9-2320-365-20-1
2-1027
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector J7-3.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire 3099
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10).
(5) If continuity is present, replace WTEC II
ECU dimmer module (para 7-13).
(6) Connect connector J7 to WTEC II ECU dimmer
module.
(7) Install PDP on dashboard with three screws.
(8) Install three washers and screws in PDP.
(9) Install kick panel (para 16-3).
