CONTINUITY TEST
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
CAUTION
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector P34 pin 1.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, go to step 20 of
this fault.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back or not
capable of making good contact.
Change 1 2-173
TM 9-2320-365-20-1
