e2. ENGINE DOES NOT CRANK (CONT)
KNOWN INFO
Is continuity present from
terminal lug TL163 to
ground?
TEST OPTIONS
NO
YES
Transmission pushbutton
shift selector in neutral (N).
Batteries OK.
Service drive lights OK.
Circuit breakers OK.
Starting motor OK.
Battery to starter cable
assembly OK.
Oil pressure switch OK.
Neutral start relay OK.
WTEC II vehicle interface
module (VIM) OK.
WTEC II cab transmission
wiring harness OK.
WTEC II transmission ECU
pushbutton shift selector
(TEPSS) OK.
Faulty relay K26.
Faulty WTEC III transmission
pushbutton shift selector
(TPSS).
Engine control cable assembly
OK.
Relay K24 OK.
Relay K1 OK.
POSSIBLE PROBLEMS
Faulty starter pushbutton
switch.
Faulty dashboard cable
assembly.
Replace starter pushbutton
switch (para 7-20).
28.
REASON FOR QUESTION
If continuity is not present,
wire 3007 is faulty. If
continuity is present, starter
pushbutton switch is faulty.
Continuity Test or
STE/ICE-R Test #91
Repair wire 3007 from terminal lug TL163
to terminal board TB2 positon 11 (para 2-40)
or replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
TM 9-2320-365-20-1
2-208 Change 1
