e2. ENGINE DOES NOT CRANK (CONT)
KNOWN INFO
CAUTION
Read CAUTION
on following page.
TEST OPTIONS
YES
NO
POSSIBLE PROBLEMS
Faulty engine control cable
assembly.
Faulty dashboard cable
assembly.
REASON FOR QUESTION
If continuity is not present,
wire 34 is faulty. If continuity
is present wire 34 is faulty.
26.
Transmission pushbutton
shift selector in neutral (N).
Batteries OK.
Service drive lights OK.
Circuit breakers OK.
Starting motor OK.
Battery to starter cable
assembly OK.
Oil pressure switch OK.
Neutral start relay OK.
WTEC II vehicle interface
module (VIM) OK.
WTEC II cab transmission
wiring harness OK.
WTEC II transmission ECU
pushbutton shift selector
(TEPSS) OK.
Relay K26 OK.
WTEC III transmission
pushbutton shift selector
(TPSS) OK.
Continuity Test or
STE/ICE-R Test #91
Is continuity present from
relay K11 socket 85 on PDP
to connector J31 pin 21?
Repair wire 34 from connector P31 socket 21 to
connector P34 socket 2 (para 2-40) or replace
engine control cable assembly (para 7-72).
Repair wire 34 from relay K11 socket 85 on
PDP to connector J31 pin 21 (para 2-40) or replace
WTEC II dashboard cable assembly (para 7-10) or
WTEC III dashboard cable assembly (para 7-11).
TM 9-2320-365-20-1
2-204 Change 1
