e2. ENGINE DOES NOT CRANK (CONT)
KNOWN INFO
TEST OPTIONS
Transmission pushbutton
shift selector in neutral (N).
Batteries OK.
Service drive lights OK.
Circuit breakers OK.
Starting motor OK.
Battery to starter cable
assembly OK.
Oil pressure switch OK.
WTEC II cab transmission
wiring harness OK.
WTEC II transmission ECU
pushbutton shift selector
(TEPSS) OK.
POSSIBLE PROBLEMS
Faulty WTEC II vehicle
interface module (VIM).
Faulty dashboard cable
assembly.
REASON FOR QUESTION
If continuity is not present,
WTEC II VIM is faulty. If
continuity is present, wire
3101 is faulty.
45.
CAUTION
Read CAUTION
on following page.
NO
YES
Replace WTEC II vehicle interface module
(VIM) (para 8-6).
Continuity Test or
STE/ICE-R Test #91
Is continuity present from
neutral start relay socket 86
on VIM to VIM connector
pin K1?
Repair wire 3101 from connector PX33 socket K1
to terminal board TB2 position 16 on PDP (para 2-40)
or replace WTEC II dashboard cable assembly (para 7-10).
TM 9-2320-365-20-1
2-242 Change 1
