Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. CAUTION                           NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back or not capable of making good contact. CONTINUITY TEST Change 1          2-251 TM 9-2320-365-20-1   (1) Disconnect connector clamp from        connector P116.   (2) Disconnect connector P116 from WTEC III        transmission ECU connector.   (3) Set multimeter to ohms.   (4) For each line of Table 2-8.3.  Connector        PX33 Ground Continuity Test perform the        following:          (a)  Connect positive (+) probe of                multimeter to connector PX33 socket.          (b)  Connect negative (-) probe of                multimeter to connector P116                position and not reading on                multimeter.   (5) If continuity is not present on either wire in        Table 2-8.3.  Connector PX33 Continuity        Test repair wire (para 2-40) or replace        WTEC III dashboard cable assembly        (para 7-11).   (6) Install PDP on dashboard with three        screws.   (7) Connect connector P116 to WTEC III        transmission ECU connector.   (8) Connect connector clamp to connector        P116. Connector PX33 Socket Connector P116 Socket Wire Table 2-8.3.  Connector PX33 Continuity Test P L A B C D E S M N R 32 15 5 6 7 8 9 14 10 3 16 143 176 170 171 172 173 174 180 175 124 136