Change 1 2-581
TM 9-2320-365-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
Marker Light
LH Side
LH Rear
Left Rear
Middle Rear
Right Rear
RH Rear
Connector
P85
P86
P54
P56
P58
RH Side
P89
P88
Connector P85 to Splice E16
Connector P86 to Splice E15
Connector P54 to Splice E15
Connector P56 to Splice E15
Connector P58 to Splice E15
Connector P89 to Splice E17
Connector P88 to Splice E17
Wire 489 Segment
NOTE
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
VOLTAGE TEST
(1) Disconnect marker light connector from
connector (refer to Table 2-12. Side
and Rear Marker Light Connectors).
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector (refer to Table 2-12.
Side and Rear Marker Light
Connectors).
(4) Connect negative (-) probe of multimeter
to ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-365-10) and note reading on
multimeter.
(6) Position main light switch to OFF
(TM 9-2320-365-10).
(7) If 12 VDC is not present, repair wire 489
(refer to Table 2-12. Side and Rear Marker
Light Connectors) (para 2-40) or replace
rear lights cable assembly (para 7-75).
Table 2-12. Side and Rear Marker Light Connectors
