CONTINUITY TEST Change 1          2-583 TM 9-2320-365-20-1   (1) Remove nut, lockwasher, terminal lug, and        lockwasher from marker light screw.        Discard lockwashers.   (2) Set multimeter to ohms.   (3) Connect positive (+) probe of multimeter        to terminal lug (refer to Table 2-12.1  Side        and Rear Marker Light Terminal Lugs).   (4) Connect negative (-) probe of multimeter to        ground and note reading on multimeter.   (5) If continuity is not present, repair wire        (refer to Table 2-12.1  Side and Rear        Marker Light Terminal Lugs) (para 2-40) or        replace rear lights cable assembly        (para 7-75).   (6) If continuity is present, replace marker        light (para 7-31).   (7) Install lockwasher, terminal lug,        lockwasher, and nut on marker light screw.   (8) Connect marker light connector to        connector (refer to Table 2-12.1.  Side and        Rear Marker Light Connectors). TL19 Wire 3095 from Terminal Lug TL19 to Terminal Lug TL20 TL20 Replace Marker Light (para 7-38) TL32 Replace Marker Light (para 7-38) Replace Marker Light (para 7-38) TL31 TL30 Connector TL15 TL16 Replace Marker Light (para 7-38) Wire 3094 from Terminal Lug TL31 to Terminal Lug TL30 Wire 3094 from Terminal Lug TL15 to Terminal Lug TL16 Wire Segment RH Side RH Rear Right Rear Middle Rear Left Rear Marker Light LH Side LH Rear Table 2-12.1.  Side and Rear Marker Light Terminal Lugs