TM 9-2320-365-20-1
2-629
CONTINUITY TEST
VOLTAGE TEST
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
WARNING
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector J62-A.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire 3050
(para 2-40) or replace warning light cable
assembly (para 22-2).
(5) If continuity is present, replace warning light
(TM 9-2320-365-10).
(1) Remove instrument panel assembly for access
(para 7-15).
(2) Set multimeter to volts dc.
(3) Disconnect connector PX12 from warning
light switch.
(4) Position main light switch to SER DRIVE
(TM 9-2320-365-10).
(5) Connect positive (+) probe of multimeter to
connector PX12-5.
(6) Connect negative (-) probe of multimeter to
ground.
(7) If 12 vdc is not present, repair wire 1575
(para 2-40) or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III dashboard
cable assembly (para 7-11).
(8) Position main light switch to OFF
(TM 9-2320-365-10).
