TM 9-2320-365-20-2
2-1327
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
VOLTAGE TEST
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
WARNING
(1) Set multimeter to volts dc.
(2) Connect positive (+) probe of multimeter to
connector P912-7.
(3) Connect negative (-) probe of multimeter to
ground.
(4) Position master power switch to on
(TM 9-2320-365-10) and note reading on
multimeter.
(5) If 24 vdc is not present, replace lighted
indicator display (para 7-16).
(6) Position master power switch to off
(TM 9-2320-365-10).
(1) Set multimeter to volts dc.
(2) Connect positive (+) probe of multimeter to
connector P912-1.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If 24 vdc is not present, repair wire 2006 (para
2-40) or replace WTEC II dashboard cable
assembly (para 7-10 or WTEC III dashboard
cable assembly (para 7-11).
(5) Connect connector P912 to connector J912.
(6) Install personnel heater (para 18-9).
