TM 9-2320-365-20-2
2-1329
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1) Remove kick panel (para 16-3).
(2) Disconnect connector P108 from connector
J108.
(3) Set multimeter to volts dc.
(4) Connect positive (+) probe of multimeter to
connector J108-12.
(5) Connect negative (-) probe of multimeter to
ground.
(6) Position master power switch to on
(TM 9-2320-365-10) and note reading on
multimeter.
(7) If 24 vdc is not present, repair wire 2010 (para
2-40) or replace auxiliary panel cable assembly
(all models except M1079 w/o winch)
(para 7-49) or M1079 w/o winch auxiliary
panel cable assembly (par 7-50).
(8) Position master power switch to off
(TM 9-2320-365-10).
(1) Set multimeter to volts dc.
(2) Connect positive (+) probe of multimeter to
connector J108-16.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If 24 vdc is not present, repair wire 2006 (para
2-40) or replace auxiliary panel cable assembly
(all models except M1079 w/o winch)
(para 7-49) or M1079 w/o/ winch auxiliary
panel cable assembly (para 7-50).
(5) Connect connector P108 to connector J108.
(6) Install kick panel (para 16-3).
VOLTAGE TEST
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
WARNING
