TM 9-2320-365-20-2
1.
START
KNOWN INFO
TEST OPTIONS
REASON FOR QUESTION
Is a diagnostic code(s)
logged in WTEC II
TEPSS and does it
return after clearing
diagnostic codes?
Engine runs.
Transmission oil level
OK.
Fuse OK.
Batteries OK.
POSSIBLE PROBLEMS
WTEC II Diagnostic
Code Reading/Code
Clearing Procedure
Fault corrected.
NO
Perform Transmission System Troubleshooting
per para 8-4, Table 8-1. WTEC II Diagnostic Code
List and Description.
YES
Diagnostic code(s)
logged in WTEC II
TEPSS.
If WTEC II TEPSS does
not display any
diagnostic codes after
clearing, an intermittent
problem was detected
and corrected. If any
diagnostic code(s) is
logged after clearing,
further troubleshooting
is required.
INITIAL SETUP
Equipment Conditions
Engine running (TM 9-2320-365-10).
f1. WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) EMITS EIGHT
SECONDS OF BEEPS AND/OR TRANSMISSION DOES NOT SHIFT GEARS
(2-1361 Blank)/2-1362