RESISTANCE TEST   (3)  Connect negative (-) prove of multimeter on         P119d and note reading on multimeter.   (4)  Connect negative (-) probe of multimeter to         all other pins in connector P119, one at a         time, and note reading on multimeter.   (5)  Connect negative (-) probe of multimeter to         ground and note reading on multimeter.   (6)  Connect positive (+) probe of multimeter to         connector P119d.   (7)  Connect negative (-) probe of multimeter to         all other pins in connector P119 (except         (P119a), one at a time, and note reading on         multimeter.   (8)  Connect negative (-) probe of multimeter to         ground and note reading on multimeter.   (9)  If correct resistance is not present in step 3,         or continuity is present in step 4, 5, 7, or 8,         notify DS Maintenance. (10)  If correct resistance is present in step 3 and         continuity is not present in step 4, 5, 7, or 8,         replace WTEC II TEPSS (para 8-2).   (1)  Set multimeter to ohms.   (2)  Connect positive (+) probe of multimeter on         P119a. CAUTION                             NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back or not capable of making good contact. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. TM 9-2320-365-20-2 Change 1          2-1395                        NOTE     Transmission sump oil temperature     sensor resistance reading is affected by     temperature.  Refer to Table 2-17.       Transmission Sump Oil Temperature     Sensor Resistance Readings for details. 1039-1118 ohms 1118-1202 ohms 1202-1286 ohms 962-1039 ohms 820-889 ohms 889-962 ohms 754-820 ohms 691-754 ohms Resistance Temperature -4° to 14°F (-20° to -10°C) 14° to 32°F (-10° to 0°C) 32° to 50°F (0° to 10°C) 50° to 68°F (10° to 20°C) 68° to 86°F (20° to 30°C) 86° to 104°F (30° to 40°C) 104° to 122°F (40° to 50°C) 122° to 140°F (50° to 60°C) Table 2-17.  Transmission Sump Oil Temperature Sensor Resistance Readings (11)  Connect connector P119 to connector         J119. (12)  Position front grille on cab with washer and         screw. (13)  Position two washers and screws in front         grille. (14)  Tighten screw to 48-60 lb-in. (5-7 N·m). (15)  Tighten two screws to 24 lb-in. (3 N·m). (16)  Clear diagnostic codes (para 8-4).