RESISTANCE TEST
TM 9-2320-365-20-2
Change 1 2-1403
Table 2-19. Connector P119 Transmission
Solenoid Resistance Test Points
Sub
Code
Positive (+) Probe
Connector P119
Negative (-) Probe
12
13
14
15
16
21
22
23
24
26
P119T
P119C
P119W
P119U
P119F
P119D
P119P
P119J
P119K
P119M
P119B
P119N
P119V
P119B
P119N
P119H
P119V
P119S
P119B
P119A
Temperature
Table 2-20. Transmission Solenoid Resistance
Readings
Resistance
4° to 16°F (-20° to -10°C)
16° to 32°F (-10° to 0°C)
32° to 50°F (0° to 10°C)
50° to 68°F (10° to 20°C)
68° to 86°F (20° to 30°C)
86° to 104°F (30° to 40°C)
104° to 122°F (40° to 50°C)
122° to 140°F (50° to 60°C)
2.50-3.12 ohms
2.62-3.25 ohms
2.74-3.38 ohms
2.86-3.50 ohms
2.98-3.62 ohms
3.09-3.75 ohms
3.21-3.88 ohms
3.33-4.00 ohms
(1) Disconnect connector P119 from connector
J119.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to connector P119. Refer to Table 2-19.
Connector P119 Transmission Solenoid
Resistance Test Points for appropriate sub
code(s) and connector P119 pin(s).
(4) Connect negative (-) probe of multimeter to
connector P119 and note reading on
multimeter. Refer to Table 2-19.
Connector P119 Transmission Solenoid
Resistance Test Points for appropriate sub
code(s) and connector P119 pin(s).
NOTE
Transmission solenoid resistance
is affected by temperature. Refer to
Table 2-20. Transmission Solenoid
Resistance Readings.
(5) If resistance reading indicates transmission
solenoid is good, replace WTEC II TEPSS
(para 8-2).
(6) If resistance reading indicates transmission
solenoid is faulty, notify DS Maintenance.
(7) Connect connector P119 to connector J119.
(8) Position front grille on cab with washer and
screw.
(9) Position two washers and screws in front
grille.
(10) Tighten screw to 48-60 lb-in. (5-7 N·m).
(11) Tighten two screws to 24 lb-in. (3 N·m).
(12) Clear diagnostic codes (para 8-4).
