(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector J119j.
(3) Connect negative (-) probe of multimeter to
connector J115-28 and note reading on
multimeter.
(4) Connect negative (-) probe of multimeter to
all other sockets in connector J115, one at
a time, and note reading on multimeter.
(5) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(6) If continuity is not present in step 3, or
continuity is present in step 4 or step 5,
replace WTEC II cab transmission
harness (para 7-86).
CONTINUITY TEST
TM 9-2320-365-20-2
Change 1 2-1413
