CONTINUITY TEST
TM 9-2320-365-20-2
Change 1 2-1441
(1) Lower cab (TM 9-2320-365-10).
(2) Remove two screws and washers from
front grille.
(3) Remove screw and washer from front grille.
(4) Remove front grille from cab.
(5) Remove instrument panel assembly for
access (para 7-15).
(6) Disconnect connector J114 (bottom
connector) at WTEC II TEPSS.
(7) Set multimeter to ohms.
(8) For each line of Table 2-25. WTEC II Cab
Transmission Harness Continuity Check:
(a) Install jumper wire across sockets in
column 1.
(b) Connect positive (+) probe of
multimeter to socket in column 2.
(c) Connect negative (-) probe of
multimeter to socket in column 3 and
note reading on multimeter.
(9) If continuity is not present on any wire in
Table 2-25. WTEC II Cab Transmission
Harness Continuity Check, replace WTEC II
cab transmission harness (para 7-86).
Table 2-25. WTEC II Cab Transmission Harness
Continuity Check
Column 2
Positive (+)
Probe to:
Column 1
Jumper Across:
Column 3
Negative (-)
Probe to:
J119F to J119Z
J119Z to J119R
J119F to J119R
J115-1
J115-1
J115-22
J115-22
J114-24
J114-24
(10) Remove jumper wire from connector J119.
