CONTINUITY TEST
TM 9-2320-365-20-2
Change 1 2-1443
(1) Disconnect connector J115 (top
connector) from WTEC II TEPSS.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to connector J114-24.
(4) Connect negative (-) probe of multimeter to
all other sockets in connector J114, one at
a time, and all sockets in connector J115,
one at a time, and note readings on
multimeter.
(5) Connect positive (+) probe of multimeter
to connector J115-1.
(6) Connect negative (-) probe of multimeter to
all other sockets in connector J115, one at
a time, and all sockets in connector J114,
one at a time, and note readings on
multimeter.
(7) Connect positive (+) probe of multimeter
to connector J115-22.
(8) Connect negative (-) probe of multimeter to
all other sockets in connector J115, one at
a time, and all sockets in connector J114,
one at a time, note readings on multimeter.
(9) If continuity is present in step 4, 6, or 8,
replace WTEC II cab transmission harness
(para 7-86).
(10) If continuity is not present in step 4, 6, and 8,
replace WTEC II TEPSS (para 8-2).
(11) Connect connector J114 (bottom connector)
to WTEC II TEPSS.
(12) Connect connector J115 (top connector) to
WTEC II TEPSS.
(13) Install instrument panel assembly (para 7-15).
(14) Connect connector P119 to connector J119.
(15) Position front grille on cab with washer and
screw.
(16) Position two washer and screws in front
grille.
(17) Tighten screw to 48-60 lb-in. (5-7 N·m).
(18) Tighten two screws to 24 lb-in. (3 N·m).
(19) Clear diagnostic codes (para 8-4).
