TM 9-2320-365-20-2
2-1482.2 Change 1
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 44, Appendix C)
Multimeter, Digital (Item 22, Appendix C)
STE/ICE-R (Item 39, Appendix C)
NOTE
1.
Does main code 23
logged in WTEC II TEPSS
return after clearing
diagnostic code?
CAUTION
Read CAUTION
on following page.
KNOWN INFO
Circuit breaker CB35 OK.
POSSIBLE PROBLEMS
Fault corrected.
TEST OPTIONS
WTEC II Diagnostic Code
Clearing procedure.
REASON FOR QUESTION
If WTEC II TEPSS does not
display any diagnostic code
after clearing, an intermittent
problem was detected and
corrected. If diagnostic code
is logged after clearing,
further troubleshooting is
required.
YES
Faulty WTEC II dashboard
cable assembly.
Faulty 10 AMP MAIN POWER
fuse.
Faulty WTEC II vehicle
interface module (VIM).
Faulty WTEC II cab
transmission harness.
Faulty WTEC II TEPSS.
Perform Electrical System Troubleshooting e1.
Circuit Breaker Does Not Operate on circuit
breaker C35 prior to begining this task.
f19A. WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN
CODE 23 AND ANY SUB CODE
START
Personnel Required
(2)
References
TM 9-4910-571-12&P
NO
