CONTINUITY TEST
CONTINUITY TEST
(1) Loosen screw in connector J116.
(2) Disconnect connector J116 from WTEC II
VIM.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter
to WTEC II VIM connector pin L1.
(5) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(6) Connect positive (+) probe of multimeter
to WTEC II VIM connector pin L2.
(7) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(8) If continuity is not present in steps (5) and
(7), replace WTEC II VIM (para 8-6).
(9) Connect connector J116 to WTEC II VIM.
(10) Tighten screw in connector J116.
(11) Install kick panel (para 16-3).
TM 9-2320-365-20-2
Change 1 2-1481
(1) Loosen screw in connector PX33.
(2) Disconnect connector PX33 from WTEC II
VIM.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter
to connector PX33-K1.
(5) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(6) Connect positive (+) probe of multimeter
to connector PX33-K2.
(7) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(8) If continuity is not present on connector
PX33-K1, repair wire 3101 (para 2-40) or
replace WTEC II dashboard cable
assembly (para 7-10).
(9) If continuity is not present on connector
PX33-K2, repair wire 3102 (para 2-40) or
replace WTEC II dashboard cable assembly
(para 7-10).
(10) Connect connector PX33 to WTEC II VIM.
(11) Tighten screw in connector PX33.
