(1) Start engine (TM 9-2320-365-10).
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter to
connector J116-E1.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) Connect positive (+) probe of multimeter to
connector J116-E2.
(6) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(7) If 12 to 14.5 vdc is not present, replace
WTEC II VIM (para 8-6).
(8) Shut down engine (TM 9-2320-365-10).
VOLTAGE TEST
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit and
cause severe burns or electrical shock.
WARNING
Change 1 2-1477
TM 9-2320-365-20-2