(1) Check to see if main code 13 sub code 12 is
active in WTEC III TPSS (para 8-5).
(2) If main code 13 sub code 12 is not active in
WTEC III TPSS, go to step 7 of this fault.
Change 1 2-1581
TM 9-2320-365-20-2
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
Loose or dirty connectors may cause
intermittent loss of power to transmission
ECU and diagnostic codes to be logged.
Ensure that all connectors are clean and tight
before performing troubleshooting. Failure to
comply may result in incorrect test results.
CAUTION
NOTE
