(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to connector P115-17.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) Connect positive (+) probe of multimeter
to connector P115-32.
(5) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(6) If resistance noted in step 3 or step 5 is
higher than 0.5 ohms, repair wire 143 (para
2-40) or replace WTEC III dashboard cable
assembly (para 7-11).
(7) Connect connector P115 to WTEC III
transmission ECU.
(8) Connect connector clamp on connector
P115.
RESISTANCE TEST
Change 1 2-1585
TM 9-2320-365-20-2
