(1) Disconnect connector clamp from
connector P116.
(2) Disconnect connector P116 from WTEC III
transmission ECU.
(3) Remove instrument panel assembly for
access (para 7-15).
(4) Disconnect connector PX33 from WTEC III
TPSS.
(5) Set multimeter to ohms.
(6) Connect positive (+) probe of multimeter
to connector P116-16.
(7) Connect negative (-) probe of multimeter to
connector PX33R and note reading on
multimeter.
(8) Connect negative (-) probe of multimeter to
all other sockets in connector PX33, one
at a time, and note reading on multimeter.
(9) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(10) If continuity is not present in step 7, or
continuity is present in step 8 or step 9,
repair wire 136 (para 2-40) or replace
WTEC III dashboard cable assembly
(para 7-11).
CONTINUITY TEST
Change 1 2-1587
TM 9-2320-365-20-2
