TM 9-2320-365-20-2
2-1127
CONTINUITY TEST
(1) Remove six screws and cover from 110/208
VAC POWER DISTRIBUTION PANEL.
(2) Loosen screw in terminal board TB4.
(3) Remove wire 1499J from terminal board TB4.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter to
wire 1499J in 110/208 VAC POWER
DISTRIBUTION PANEL.
(6) Connect negative (-) probe of multimeter to
wire 1499J in lighting fixture DS81 and note
reading on multimeter.
(7) If continuity is not present, repair or replace
wire 1499J between lighting fixtures DS80 and
DS81 (para 2-40).
(8) Install wire 1499J on terminal board TB4.
(9) Tighten screw in terminal board TB4.
