TM 9-2320-365-20-3
4-16. THROTTLE POSITION SENSOR (TPS) CABLE ASSEMBLY REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Conditions
Batteries disconnected (para 7-48).
Cab raised (TM 9-2320-365-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 44, Appendix C)
Materials/Parts
Pin, Cotter (Item 202, Appendix G)
a. Removal.
(1) Disconnect electrical connector (1) from TPS cable
assembly (2).
(2) Remove three nuts (3), washers (4), screws (5), and
TPS cable assembly (2) from bracket (6).
(3) Remove cotter pin (7) and washer (8) from stud (9).
Discard cotter pin.
(4) Remove TPS cable assembly (2) from stud (9).
(5) Release latch (10) on clamp (11).
(6) Remove TPS cable assembly (2) from clamp (11).
(7) Remove TPS cable assembly (2) from engine.
4-85