TM 9-2320-365-20-3
7-15. INSTRUMENT PANEL ASSEMBLY REPLACEMENT/REPAIR (CONT)
NOTE
All electrical gages are installed the same
way. FUEL gage shown.
(23) Position FUEL gage (32) in instrument panel (2) with
mounting ring (33) and two self-locking nuts (34).
(24) Tighten two self-locking nuts (34) to 9 lb-in. (1 N·m).
(25) Install two protective caps (35) on FUEL gage (32).
(26) Perform steps (23) through (25) on remaining gages.
NOTE
All rocker switches are installed the same
way. Radiator fan off switch shown.
(27) Install radiator fan off switch (36) in instrument panel (2).
(28) Perform step (27) on remaining rocker switches.
d. Installation.
(1) Position instrument panel assembly (1) on dashboard
(2).
NOTE
Perform steps (2) through (4) on vehicles
equipped with WTEC II transmission controls.
(2) Connect connector J114 (3) to WTEC II TEPSS (4).
(3) Connect connector J115 (5) to WTEC II TEPSS (4).
(4) Install terminal lug (6) on instrument panel assembly (1)
with washer (7) and screw (8).
7-100
