TM 9-2320-365-20-3
7-45. BATTERY TESTER REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Battery box cover removed (TM 9-2320-365-10).
Tools and Special Tools
Goggles, Industrial (Item 15, Appendix C)
Apron, Rubber (Item 3, Appendix C)
Gloves, Rubber (Item 13, Appendix C)
Puller, Battery Terminal (Item 28, Appendix C)
Tool Kit, Genl Mech (Item 44, Appendix C)
Materials/Parts
Dispenser, Pressure Sensitive Adhesive Tape
(Item 21, Appendix D)
Grease, Automotive and Artillery (GAA)
(Item 23, Appendix D)
Lockwasher (Item 78, Appendix G)
WARNING
• Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle.
Jewelry can catch on equipment and cause injury or short across electrical circuit and cause
severe burns or electrical shock. Batteries can explode from a spark. Battery acid is harmful to
skin and eyes. Always wear eye protection when working with batteries.
• Negative battery terminals must be disconnected first. Failure to comply may result in serious
injury or death to personnel.
a. Removal.
NOTE
Tag cables and connection points prior to
disconnecting.
(1) Remove nut (1) and lockwasher (2) from battery ground
cable (3). Discard lockwasher.
NOTE
Perform step (2) on vehicles equipped with
cargo arctic heater.
(2) Remove terminal lug TL2 (4) from battery ground cable
(3).
(3) Remove terminal lugs TL50A (5), TL48 (6), and battery
tester terminal lug (7) from battery ground cable (3).
7-184
