TM 9-2320-365-20-3
7-57. RIGHT-HAND DOOR AND CAB MARKER LIGHTS CABLE ASSEMBLY
REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Batteries disconnected (para 7-48).
PDP cover removed (para 16-2).
Tools and Special Tools
Tool Kit, Genl Mech (Item 44, Appendix C)
Materials/Parts
Ties, Cable, Plastic (Item 76, Appendix D)
Lockwasher (4) (Item 71, Appendix G)
Lockwasher (2) (Item 81, Appendix G)
Gasket (2) (Item 23, Appendix G)
a. Removal.
NOTE
• Note routing of right-hand door and cab marker
lights cable assembly prior to removal.
• Remove plastic cable ties as required.
(1) Remove three screws (1) and washers (2) from PDP (3).
(2) Remove three screws (4) from PDP (3).
(3) Lift PDP (3) outward to gain access.
(4) Remove two nuts (5), lockwashers (6), washers (7), and
cover (8) from terminal board TB1 (9).
Discard
lockwashers.
(5) Disconnect terminal lug TL73 (10) from terminal board
TB1 (9) position 1.
(6) Disconnect terminal lug TL71 (11) from terminal board
TB2 (12) position 2.
Change 1
7-233
