TM 9-2320-365-20-3
7-75. REAR LIGHTS CABLE ASSEMBLY REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Batteries disconnected (para 7-48).
Kick panel removed (para 16-3).
Exhaust muffler removed (para 5-2).
Bottom radiator fan shroud removed (para 6-4).
Tools and Special Tools
Tool Kit, Genl Mech (Item 44, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
Wrench, Torque, 0-200 lb-in. (Item 58, Appendix C)
Socket Set, Socket Wrench (Item 34, Appendix C)
Materials/Parts
Dispenser, Pressure Sensitive Adhesive Tape
(Item 21, Appendix D)
Ties, Cable, Plastic (Item 76, Appendix D)
Lockwasher (3) (Item 102.1, Appendix G)
Lockwasher (4) (Item 102.2, Appendix G)
Lockwasher (5) (Item 71, Appendix G)
Nut, Self-Locking (8) (Item 134, Appendix G)
Nut, Self-Locking (11) (Item 116, Appendix G)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
Note routing of rear lights cable assembly
and clamps prior to removal.
(1) Remove two self-locking nuts (1), clamps (2), and
screws (3) from LH taillight carrier (4). Discard self-
locking nuts.
(2) Remove two clamps (2) from rear lights cable assembly
(5).
Change 1
7-303
