TM 9-2320-365-20-3
7-82. START AND CHARGING CABLE ASSEMBLY REPLACEMENT (CONT)
NOTE
• All five clamps are removed the same way.
One shown.
• Step (36) requires the aid of an assistant.
(36) Remove self-locking nut (82), screw (83), and clamp (84)
from frame rail (85). Discard self-locking nut.
(37) Remove start and charging cable assembly (8) from
clamp (84).
(38) Perform steps (36) and (37) on remaining four clamps.
(39) Remove start and charging cable assembly (8) from
vehicle.
b. Installation.
NOTE
Install plastic cable ties as required.
(1) Position start and charging cable assembly (1) on
vehicle.
NOTE
All five clamps are installed the same way.
One shown.
(2) Position start and charging cable assembly (1) in clamp
(2).
NOTE
Steps (3) and (4) require the aid of an
assistant.
(3) Position clamp (2) on frame rail (3) with screw (4) and
self-locking nut (5).
(4) Tighten self-locking nut (5) to 120-144 lb-in. (14-16 N·m).
(5) Perform steps (2) through (4) on remaining four clamps.
7-350
Change 1
