TM 9-2320-365-20-3
7-82. START AND CHARGING CABLE ASSEMBLY REPLACEMENT (CONT)
NOTE
Perform steps (13.1) through (14) on start
and charging cable assemblies equipped with
P81 connector.
(13.1) Cut connector P81 (16) from start and charging cable
assembly (1).
(13.2) Remove band marker (17) from start and charging cable
assembly (1).
NOTE
Remove electrical tape and insulation
sleeving as required.
(13.3) Remove convoluted tubing (17.1) from two wires (17.2
and 17.3).
NOTE
Measure wires from body of start and
charging cable assembly.
(13.4) Cut wire (17.2) to 3 in. (7.6 cm) in length.
(13.5) Cut wire (17.3) to 4 in. (10.2 cm) in length.
(13.6) Remove 0.38 in. (1 cm) of insulation from two wires
(17.2 and 17.3).
(13.7) Cut insulation sleeving (17.4) 1.5 in. (3.8 cm).
(13.8) Position insulation sleeving (17.4) on wire (17.3).
(13.9) Install conductor splice (17.5) on two wires (17.2 and
17.3).
(13.10) Install insulation sleeving (17.4) on conductor splice
(17.5).
NOTE
Install electrical tape as required.
(14) Install convoluted tubing (17.1) on two wires (17.2 and
17.3).
7-350.2
Change 1
