TM 9-2320-365-20-3
b. Installation.
(1) Install WTEC III TPSS (1) in instrument panel assembly
(2).
(2) Position two brackets (3) and self-locking nuts (4) on
WTEC III TPSS (1).
(3) Tighten two self-locking nuts (4) to 11-13 lb-in. (1-2
N·m).
(4) Connect connector PX33 (5) to WTEC III TPSS
connector (6).
c. Calibration.
NOTE
WTEC III TPSS requires calibration after
replacement. Calibration is accomplished in
steps (1) through (4).
(1) Position master power switch to on and wait for neutral
(N) indication from WTEC III TPSS (TM 9-2320-365-10).
(2) Position master power switch to off (TM 9-2320-365-10).
(3) Perform steps (1) and (2) four more times.
(4) Position master power switch to on (TM 9-2320-365-10).
(5) Start engine (TM 9-2320-365-10).
(6) Check VOLTS gage for charge indication (TM 9-2320-
365-10).
NOTE
Transmission shifting may be rough until
WTEC III TPSS determines proper shift
points. Operating vehicle through each gear
range several times will allow WTEC III TPSS
to determine proper shift points.
(7) Test drive vehicle and check operation through all gear
ranges several times (TM 9-2320-365-10).
(8) Shut down engine (TM 9-2320-365-10).
End of Task.
8-7
