TM 9-2320-365-20-3
8-8. WTEC III TRANSMISSION CONTROLS INITIAL INSTALLATION
This task covers:
a. Initial Installation
b. WTEC III TPSS Calibration
INITIAL SETUP
Equipment Conditions
WTEC II dashboard cable assembly removed
(para 7-10).
WTEC II TEPSS removed (para 8-2).
WTEC II VIM removed (para 8-6).
WTEC II cab transmission harness removed
(para 7-86).
Tools and Special Tools
Tool Kit, Genl Mech (Item 44, Appendix C)
Wrench, Torque, 0-75 lb-in. (Item 86, Appendix B)
Drill, Portable, Electric (Item 7, Appendix C)
Drill Set, Twist (Item 6, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
Personnel Required
(2)
a. Initial Installation.
(1) Install WTEC III TPSS (1) in instrument panel assembly
(2).
(2) Position two brackets (3) and self-locking nuts (4) on
rear of WTEC III TPSS (1).
(3) Tighten two self-locking nuts (4) to 11-13 lb-in. (1-2
N·m).
NOTE
Perform steps (4) through (6) on vehicles
equipped with auxiliary panel.
(4) Disconnect connector J108 (5) from connector P108 (6).
(5) Disconnect connector J210 (7) from connector P210 (8).
(6) Pull auxiliary panel cable assembly (9) through forward
hole in dashboard (10).
8-26
