TM 9-2320-365-20-3
9-2. DRIVE SHAFT AND UNIVERSAL JOINT REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Cleaning/Inspection
d. Assembly
e. Installation
f. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 44, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
Hammer, Hand (Item 18, Appendix C)
Materials/Parts
Grease, Automotive and Artillery (GAA) (Item
23, Appendix D)
Materials/Parts (Cont)
Solvent, Dry Cleaning (Item 71, Appendix D)
Rag, Wiping (Item 51, Appendix D)
Spider, Universal Joint, Vehicular (Item 260.1,
Appendix G)
Seal, Shaft (Item 255.2, Appendix G)
Screw, Cap (8 per drive shaft) (Item 237.1, Appendix
G)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the possibility
of falling debris.
Failure to comply may
result in injury to personnel.
a. Removal.
NOTE
Both drive shafts are removed the same way.
Front drive shaft shown.
(1) Remove four screws (1) and two bearing cups (2) from
drive yoke (3). Discard screws.
(2) Slide drive shaft (4) from side to side and separate
universal joint (5) from drive yoke (3).
(3) Perform steps (1) and (2) on opposite end of drive shaft
(4).
9-2
Change 1
