TM 9-2320-365-20-3
10-2. WHEEL BEARING/CENTRAL TIRE INFLATION SYSTEM (CTIS) SEAL
REPLACEMENT (CONT)
(10) Apply two wraps of duct tape on splined and
threaded portions of spindle (12).
CAUTION
Use care when installing wheel end hub
assembly on spindle. Failure to comply may
damage CTIS seal and cause early failure of
CTIS seals.
(11) Install wheel end hub (2) on spindle (12).
(12) Remove duct tape from spindle (12).
(13) Install outer wheel bearing cone (13) in wheel
end hub (2).
(14) Position wheel bearing nut (14) on spindle (12).
CAUTION
Rotate wheel end hub to the left and to the
right while tightening wheel bearing nut.
Failure to comply may result in damage to
equipment.
(15) Tighten wheel bearing nut (14) to 50 lb-ft (68 N·m).
(16) Loosen wheel bearing nut (14) one quarter turn (90-
degrees).
CAUTION
Do not tighten wheel bearing nut more than
10-20 lb-ft (14-27 N·m). Failure to comply
may result in damage to equipment.
(17) Tighten wheel bearing nut (14) to 10-20 lb-ft (14-27
N·m).
10-8
