TM 9-2320-365-20-3
11-3. REAR BRAKE SHOES REPLACEMENT/ADJUSTMENT (CONT)
c. Installation.
(1) Turn two adjusting screws (1) in plunger housings (2)
until they bottom.
(2) Apply a thin film of grease to slots (3) in two anchor
plungers (4), adjusting screws (1), and inside of two
holddown clips (5).
CAUTION
• Do not rely on automatic adjusters to take up
excessive initial clearance.
Tightening
adjusting screws against plunger housings
may result in failure of automatic adjusters to
function properly.
Failure to comply may
result in damage to equipment.
• Brake shoe ends stamped ADJUSTER are
positioned on adjusting screws. Failure to
comply may result in damage to equipment.
(3) Loosen two adjusting screws (1) 1/2 turn or until slots
(3) are aligned with brake shoes (6).
(4) Install two brake shoes (6) in holddown clips (5) with
ends seated in slots in adjusting screws (1) and anchor
plungers (4).
(5) Install two return springs (7) on brake shoes (6).
11-12
Change 1
