TM 9-2320-365-20-4
16-48. M1079 HEATER THERMOSTAT CONNECTOR REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
AC power disconnected (TM 9-2320-365-10).
Batteries disconnected (para 7-48).
LH and RH doors opened (115 degrees) (TM 9-2320-
365-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 44, Appendix C)
Tool Kit, Auto Fuel (Item 42, Appendix C)
Heater, Gun Type, Electric (Item 20, Appendix B)
Soldering Iron, Electric (Item 72, Appendix B)
Materials/Parts
Lockwasher (4) (Item 79, Appendix G)
Dispenser, Pressure Sensitive Adhesive Tape
(Item 21, Appendix D)
Lockwasher (16) (Item 81, Appendix G)
Insulation Sleeving, Electrical (Item 31, Appendix
D)
Solder, Tin Alloy (Item 70, Appendix D)
a. Removal.
(1) Remove 16 screws (1), lockwashers (2), washers (3),
and raceway cover (4) from raceway (5).
Discard
lockwashers.
(2) Disconnect connector J166 (6) from connector P166 (7).
NOTE
Perform step (3) if heater kit is installed.
(3) Disconnect connector P245 (8) from connector J245 (9).
(4) Remove dust cap (10) from connector J245 (9).
(5) Remove nut (11), lockwasher (12), screw (13) and
dustcap (10) from connector J245 (9). Discard
lockwasher.
Change 1
16-295
