TM 9-2320-365-20-2
2-1325
CONTINUITY TEST
(1) Open van body RH door (TM 9-2320-365-10).
(2) Remove four screws from lighted indicator
display.
(3) Remove lighted indicator display from
instrument panel assembly.
(4) Disconnect connector PX7 from lighted
indicator display.
(5) Remove personnel heater for access
(para 18-9).
(6) Disconnect connector P912 from connector
J912.
(7) Set multimeter to ohms.
(8) Connect positive (+) probe of multimeter to
connector PX7-28.
(9) Connect negative (-) probe of multimeter to
connector P912-7 and note reading on
multimeter.
(10) If continuity is not present, repair wire 2010
(para 2-40) or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III dashboard
cable assembly (para 7-11).
(11) Connect connector PX7 to lighted indicator
display.
(12) Position lighted indicator display in instrument
panel assembly with four screws.
(13) Tighten four screws to 6-10 lb-in. (1 N·m).