TM 9-2320-365-20-1
2-967
CONTINUITY TEST
(1) Disconnect connector P215 from connector
J215.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
connector J210-8.
(4) Connect negative (-) probe of multimeter to
connector P215-1 and note reading on
multimeter.
(5) If continuity is not present, repair wire 2008
(para 2-40) or replace PTO cable assembly
(para 7-77) or arctic kit w/PTO cable assembly
(para 20-13).
(6) Connect connector P210 to connector J210.
(7) Install kick panel (para 16-3).
