TM 9-2320-365-20-1
2-331
CONTINUITY TEST
(1) Disconnect connector J31 from connector
P31.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
connector PX6-4.
(4) Connect negative (-) probe of multimeter to
connector J31-11 and note reading on
multimeter.
(5) If continuity is not present, repair wire 36
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-141).
(6) If continuity is present, repair wire 36
(para 2-40) or replace engine control cable
assembly (para 7-72).
(7) Connect connector J31 to connector P31.
(8) Connect connector PX6 to engine oil pressure
gage connector.
(9) Connect connector clamp on engine oil
pressure gage connector.
(10) Install instrument panel assembly (para 7-15).
