NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back or not
capable of making good contact.
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
CAUTION
CONTINUITY TEST
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
CTIS ECU connector pin U.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is present, replace CTIS ECU
(para 12-6).
(5) Connect connector P110 to CTIS ECU.
(1) Disconnect connector P110 from CTIS ECU.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
connector P110 socket U.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is present, repair wire 1793
from connector P110 socket U to connector
P111 socket B (para 2-40) or replace CTIS
cable assembly (para 7-53).
Change 1 2-344.5
TM 9-2320-365-20-1
