TM 9-2320-365-20-1
2-469
CONTINUITY TEST
(1) Remove personnel heater for access (para 18-9).
(2) Disconnect connector P913 from connector
J913.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
PX7-10.
(5) Connect negative (-) probe of multimeter to
J913-13 and note reading on multimeter.
(6) If continuity is not present, repair wire 2021
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(7) Connect lighted indicator display to connector
PX7.
(8) Position lighted indicator display in instrument
panel assembly with four screws.
(9) Tighten four screws to 6-10 lb-in. (1 N·m).
(10) Connect batteries (para 7-48).