TM 9-2320-365-20-1
2-511
CONTINUITY TEST
(1) Remove four screws from lighted indicator
display.
(2) Remove lighted indicator display from instrument
panel assembly.
(3) Disconnect connector PX7 from lighted indicator
display.
(4) Loosen four captive screws in lamp mounting
panel.
(5) Remove lamp mounting panel from lighted
indicator display housing.
(6) Remove master stop indicator lamps from
printed circuit board.
(7) Set multimeter to ohms.
(8) Check continuity through each master stop
indicator lamp and note reading on multimeter.
(9) If continuity is not present, replace master stop
indicator lamps (para 7-16).
(10) If continuity is present, replace lighted indicator
display (para 7-16).
(11) Install master stop indicator lamps in printed
circuit board.
(12) Install lamp mounting panel in lighted indicator
display housing.
(13) Tighten four captive screws in lamp mounting
panel.
(14) Connect lighted indicator display to connector
PX7.
(15) Position lighted indicator display in instrument
panel assembly with four screws.
(16) Tighten four screws to 6-10 lb-in. (1 N·m).
(17) Connect batteries (para 7-48).
