TM 9-2320-365-20-2
2-2085
CONTINUITY TEST
CONTINUITY TEST
(1) Lift instrument panel assembly outward to
gain access (para 7-15).
(2) Disconnect connector P31 from connector
J31.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter
to connector P39-2.
(5) Connect negative (-) probe of multimeter
to connector P31-17 and note reading
on multimeter.
(6) If continuity is not present, repair wire 32
(para 2-40) or replace engine control cable
assembly (para 7-72).
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector P39-1.
(3) Connect negative (-) probe of multimeter to
connector P31-9 and note reading on
multimeter.
(4) If continuity is not present, repair wire 3028
(para 2-40) or replace engine control cable
assembly (para 7-72).
(5) Connect connector P39 to connector J39.
(6) Connect connector clamp to connector J39.
