TM 9-2320-365-20-2
2-2087
CONTINUITY TEST
CONTINUITY TEST
(1) Remove screw and terminal lug TL178
from audible alarm.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
connector J31-17.
(4) Connect negative (-) probe of multimeter to
terminal lug TL178 and note reading on
multimeter.
(5) If continuity is not present, repair wire 32
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6) If continuity is present, replace audible
alarm (para 7-35).
(7) Install terminal lug TL178 on audible
alarm with screw.
(8) Connect connector P31 to connector J31.
(9) Install instrument panel assembly (para 7-15).
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
connector J31-9.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire 3028
(para 2-40) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
