TM 9-2320-365-20-3
7-22. COOLANT TEMPERATURE LIGHT SWITCH REPLACEMENT (CONT)
NOTE
Remove plastic cable ties as required.
(5) Disconnect
connector
clamp
(4)
from
coolant
temperature light switch (5).
(6) Disconnect connector P37 (6) from coolant temperature
light switch (5).
(7) Remove coolant temperature light switch (5) from
thermostat housing (7).
b. Installation.
WARNING
Adhesives, solvents, and sealing com-
pounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. Keep away from open fire
and use in a well-ventilated area. If
adhesive, solvent, or sealing compound
gets
on
skin
or
clothing,
wash
immediately with soap and water. Failure
to comply may result in injury to
personnel.
(1) Apply antiseize compound to threads of coolant
temperature light switch (1).
(2) Position coolant temperature light switch (1) in
thermostat housing (2).
(3) Tighten coolant temperature light switch (1) to 20-23 lb-ft
(27-31 N·m).
(4) Connect connector P37 (3) to coolant temperature light
switch (1).
NOTE
Install plastic cable ties as required.
(5) Connect connector clamp (4) on coolant temperature
light switch (1).
7-120
