TM 9-2320-365-20-3
11-5. REAR BRAKE PLUNGER ASSEMBLY REPLACEMENT/REPAIR (CONT)
e. Installation.
CAUTION
Adjusting sleeve must bottom on the
shoulder inside the plunger. Threading
adjusting screw too far into adjusting
sleeve will cause automatic adjuster not
to function.
NOTE
Install plungers in same location as
removed and align keyways in anchor/
adjusting plungers with hole in plunger
housings.
(1) Install adjusting plunger assembly (1) in plunger
housing (2).
NOTE
Make certain grooves in pawl assembly
end engage in adjusting sleeve grooves.
(2) Position lockwasher (3) and pawl assembly (4) in
plunger housing (2).
(3) Tighten pawl assembly (4) to 15-25 lb-ft (20-34 N·m).
NOTE
• One anchor (solid) and one adjusting plunger
must be installed in each plunger housing.
• Install anchor plunger marked "L" in left
plunger housing.
Install anchor plunger
marked "R" in right plunger housing.
(4) Apply film of grease on anchor plunger (5).
(5) Install and seat seal (6) and anchor plunger (5) in
plunger housing (2).
(6) Position lockwasher (7) and guide screw (8) in plunger
housing (2).
(7) Tighten guide screw (8) to 15-25 lb-ft (20-34 N·m).
11-28
